Search repair guides

Find repair guides, manuals, symptoms, and error codes across the knowledge base.

Models

Manuals

Symptoms

The correct wet or damp cycle leaves pooling or substantially more water than expected.
The robot cancels a mission for a navigation problem or ends somewhere other than the Home Base after route and map state are ruled out.
The robot charges fully, but ends early with low battery, repeatedly recharges, or cannot reach the Home Base before Error 46.
The robot repeatedly reverses, circles, or turns away on a clear, level hard floor after placement causes are ruled out.
The job ends with a docking problem or the robot cannot find the Home Base after placement, clearance, and map-start checks are corrected.
The robot wakes but the battery level does not rise on the Home Base, or the app announces a charging error.
The top lid stands proud, will not latch, or the robot reports Error 45 when a job starts.
The app reports Error 21, 25, 34, 38, 39, 47, 66, or 76 and the robot cannot reliably continue.
The robot cannot sense or drive the left wheel, announces Error 7, pulls right, or stops at startup.
The robot cannot sense or drive the right wheel, announces Error 10, pulls left, or stops at startup.
The robot is charged but cannot drive off the Home Base when a job begins after clearance and placement are proven.
The robot stops with Error 68 because its camera failed during the cleaning job.
The tank is filled to the top and installed flat, but the red sweep or Error 37 still says to fill it.
The pass count or spray behavior does not match the installed wet, damp, or dry pad.
Water sprays, but the stream is shorter or weaker than normal.
The blade leaves the line, flexes excessively, bends, or breaks during an otherwise controlled cut.
Water escapes while filling, carrying, cleaning, or storing the robot.
The saw, battery, or charger becomes abnormally hot or repeatedly shuts down after warming.
The jet pulses irregularly, sprays off-pattern, or carries visible contaminated water.
The drill runs steadily but drills slowly or cannot drive a normal fastener with correct setup.

Failure Modes

part