Search repair guides
Find repair guides, manuals, symptoms, and error codes across the knowledge base.
The same rooms now exhaust a full charge far earlier than the owner baseline.
The robot runs normally but the charged battery lasts far less than a typical job.
The robot charges fully, but ends early with low battery, repeatedly recharges, or cannot reach the Home Base before Error 46.
The correct wet or damp cycle leaves pooling or substantially more water than expected.
The robot cancels a mission for a navigation problem or ends somewhere other than the Home Base after route and map state are ruled out.
The tank is filled to the top and installed flat, but the red sweep or Error 37 still says to fill it.
The robot refuses charge because the pack temperature is outside normal range.
The 200-series robot is awake nearby, but the iRobot app cannot add or connect to it.
The pad no longer lies flat and interferes with smooth travel.
The robot drives and sprays, but the cleaning head lacks its normal scrubbing vibration with a wet pad.
The Clean Base has no status response or cannot pass charge to the robot.
The battery will not insert fully, click into place, remain retained, or release normally.
The robot moves, but one wheel makes repeatable noise or feels rough through rotation.
The robot reports four beeps immediately after an attempted start.
The robot will not start, or stops after a pad falls off, and reports three beeps.
The robot wakes but the battery level does not rise on the Home Base, or the app announces a charging error.
The robot is charged but cannot drive off the Home Base when a job begins after clearance and placement are proven.
The job ends with a docking problem or the robot cannot find the Home Base after placement, clearance, and map-start checks are corrected.
The robot repeatedly reverses, circles, or turns away on a clear, level hard floor after placement causes are ruled out.
The Clean Base still reports a bag condition after the owner checks the bag.
FM-06: RUNTIME IS MUCH SHORTER THAN THE ESTABLISHED BASELINE
FM-02: THE ROBOT WILL NOT CHARGE OR SHOWS A CHARGING ERROR
FM-02: THE WALL CHARGER HAS NO INDICATOR OR POWER
FM-03: THE BATTERY NEVER REACHES A FULL CHARGE
FM-06: THE BATTERY WILL NOT LATCH OR STAY SEATED
FM-01: THE ROBOT WILL NOT TURN ON OR WAKE
FM-25: THE PAD EJECT SLIDER WILL NOT RELEASE THE PAD
FM-13: THE CLEANING PAD WILL NOT SLIDE IN OR EJECT
FM-16: THE LID WILL NOT CLOSE OR THE APP SAYS CLOSE THE LID
FM-15: THE ROBOT BACKS UP, TURNS, SPINS, OR WILL NOT TRACK STRAIGHT
FM-21: THE SPRAY SPUTTERS, IS UNEVEN, OR CONTAINS RESIDUE
FM-24: THE CLEANING PAD WILL NOT SLIDE INTO THE TRACKS OR LATCH
FM-26: THE ROBOT CHOOSES THE WRONG MOTION OR WETNESS FOR THE PAD
FM-28: THE PAD DRAGS, BUNCHES, SEPARATES, OR RUBS A WHEEL
FM-30: THE ROBOT CROSSES THE ONBOARD VIRTUAL WALL BOUNDARY
FM-06: THE ROBOT BACKS UP, SPINS, OR TURNS IN PLACE UNEXPECTEDLY
FM-03: RUNTIME IS MUCH SHORTER THAN NORMAL
FM-07: NAVIGATION FAILS OR THE JOB ENDS AWAY FROM ITS START
FM-02: THE CLEAN BASE HAS NO AC POWER OR WILL NOT CHARGE THE ROBOT
FM-04: CHARGING IS BLOCKED BECAUSE THE BATTERY IS TOO WARM OR TOO COLD
