Search repair guides

Find repair guides, manuals, symptoms, and error codes across the knowledge base.

Models

Manuals

Symptoms

The robot will not start, or stops after a pad falls off, and reports three beeps.
The robot is charged but cannot drive off the Home Base when a job begins after clearance and placement are proven.
The top lid stands proud, will not latch, or the robot reports Error 45 when a job starts.
The robot cannot sense or drive the left wheel, announces Error 7, pulls right, or stops at startup.
The robot cannot sense or drive the right wheel, announces Error 10, pulls left, or stops at startup.
The robot wakes but the battery level does not rise on the Home Base, or the app announces a charging error.
The robot reports four beeps immediately after an attempted start.
The robot drives and sprays, but the cleaning head lacks its normal scrubbing vibration with a wet pad.
The robot repeatedly reverses, circles, or turns away on a clear, level hard floor after placement causes are ruled out.
The job ends with a docking problem or the robot cannot find the Home Base after placement, clearance, and map-start checks are corrected.
The 200-series robot is awake nearby, but the iRobot app cannot add or connect to it.
The robot cancels a mission for a navigation problem or ends somewhere other than the Home Base after route and map state are ruled out.
The robot charges fully, but ends early with low battery, repeatedly recharges, or cannot reach the Home Base before Error 46.
The pad no longer lies flat and interferes with smooth travel.
The robot moves, but one wheel makes repeatable noise or feels rough through rotation.
The correct wet or damp cycle leaves pooling or substantially more water than expected.
The tank is filled to the top and installed flat, but the red sweep or Error 37 still says to fill it.
Pressing CLEAN produces no light, sound, or response, whether the robot is on or off the Home Base.
A correct m Series pad binds in the tracks, will not seat flat, or will not release when the eject button is pressed.
The cool saw starts, then stops during a brief no-load test or light cut before heat builds.

Failure Modes

part