Search repair guides

Find repair guides, manuals, symptoms, and error codes across the knowledge base.

Models

Manuals

IROBOT BRAAVA JET 250 Repair Manual

Symptoms

The pack will not click into the rear bay or springs loose during handling.
The battery will not insert fully, click into place, remain retained, or release normally.
The robot will not start, or stops after a pad falls off, and reports three beeps.
The rear caster chatters, drags, squeaks, wobbles, or refuses to swivel.
The blade leaves the line, flexes excessively, bends, or breaks during an otherwise controlled cut.
The robot drives and sprays, but the cleaning head lacks its normal scrubbing vibration with a wet pad.
The cool saw starts, then stops during a brief no-load test or light cut before heat builds.
The drill runs steadily but drills slowly or cannot drive a normal fastener with correct setup.
The blade strokes steadily but cuts slowly, stalls easily, or needs excessive feed force.
The 200-series robot is awake nearby, but the iRobot app cannot add or connect to it.
The brush-frame door sits proud, springs open, or will not latch securely.
The robot moves, but one wheel makes repeatable noise or feels rough through rotation.
The shoe will not pivot freely, is bent or loose, or will not sit firmly against the work.
The Clean Base has no status response or cannot pass charge to the robot.
The cool drill begins to run, then stops during a brief no-load test or light work.
The charger will not begin or complete charging, or its green light does not behave normally.
The pad no longer lies flat and interferes with smooth travel.
The correct wet or damp cycle leaves pooling or substantially more water than expected.
The robot reports four beeps immediately after an attempted start.
The robot wakes but the battery level does not rise on the Home Base, or the app announces a charging error.

Failure Modes

part