Search repair guides

Find repair guides, manuals, symptoms, and error codes across the knowledge base.

Models

Symptoms

The bit jams, the motor stalls, or the drill twists sharply in the hands during work.
The chuck opens and closes, but the bit slips, pulls out, or ejects during normal work.
The cool drill begins to run, then stops during a brief no-load test or light work.
The blade strokes steadily but cuts slowly, stalls easily, or needs excessive feed force.
The chuck sleeve will not turn enough to move the jaws or admit a normal straight bit.
The drill runs steadily but drills slowly or cannot drive a normal fastener with correct setup.
The running saw jumps, vibrates against the work, snags, or kicks backward or sideways.
The blade leaves the line, flexes excessively, bends, or breaks during an otherwise controlled cut.
The shoe will not pivot freely, is bent or loose, or will not sit firmly against the work.
The cool saw starts, then stops during a brief no-load test or light cut before heat builds.
The pack will not click into the rear bay or springs loose during handling.
The battery will not insert fully, click into place, remain retained, or release normally.
The battery will not slide fully into the handle, stay retained, or release normally.
The robot stops with Error 68 because its camera failed during the cleaning job.
The charger will not begin or complete charging, or its green light does not behave normally.
The tool-free blade-clamp release lever will not reach full open or close securely.
The bin will not seat flush, the filter will not stay placed, or detection fails.
The pad card stops short, binds, or will not remain seated in both underside rails.
The pass count or spray behavior does not match the installed wet, damp, or dry pad.
The Clean Base has no status response or cannot pass charge to the robot.

Failure Modes

part