Search repair guides

Find repair guides, manuals, symptoms, and error codes across the knowledge base.

Models

Manuals

Symptoms

Charging starts only after repositioning or drops out before completion.
The robot powers down before the job is complete and gives no repeatable beep count.
The robot charges fully, but ends early with low battery, repeatedly recharges, or cannot reach the Home Base before Error 46.
The same rooms now exhaust a full charge far earlier than the owner baseline.
The cool saw starts, then stops during a brief no-load test or light cut before heat builds.
The robot cancels a mission for a navigation problem or ends somewhere other than the Home Base after route and map state are ruled out.
The robot repeatedly reverses, circles, or turns away on a clear, level hard floor after placement causes are ruled out.
The 200-series robot is awake nearby, but the iRobot app cannot add or connect to it.
The pad no longer lies flat and interferes with smooth travel.
The robot moves, but one wheel makes repeatable noise or feels rough through rotation.
The robot stops or will not proceed and reports one beep after the two-tone distress sound.
The robot will not start, or stops after a pad falls off, and reports three beeps.
The correct wet or damp cycle leaves pooling or substantially more water than expected.
The robot refuses to start and reports two beeps after the two-tone distress sound.
The robot reports four beeps immediately after an attempted start.
The robot reports ten beeps after the distress sound.
The robot stops with a drive wheel hanging over a step or threshold and reports six beeps.
The robot drives and sprays, but the cleaning head lacks its normal scrubbing vibration with a wet pad.
The robot wakes but the battery level does not rise on the Home Base, or the app announces a charging error.
A wet-mop job runs with little or no liquid, or Error 44 reports that the pump did not start after wet setup is correct.

Failure Modes

part