Search repair guides

Find repair guides, manuals, symptoms, and error codes across the knowledge base.

Models

Manuals

Symptoms

A battery message remains after a pack is installed and the cover is closed.
The pack will not click into the rear bay or springs loose during handling.
The pass count or spray behavior does not match the installed wet, damp, or dry pad.
The correct wet or damp cycle leaves pooling or substantially more water than expected.
The robot runs normally but the charged battery lasts far less than a typical job.
The tank is filled to the top and installed flat, but the red sweep or Error 37 still says to fill it.
The 200-series robot is awake nearby, but the iRobot app cannot add or connect to it.
The robot charges fully, but ends early with low battery, repeatedly recharges, or cannot reach the Home Base before Error 46.
The charger light remains dark with the charger connected to a known live outlet.
The pad no longer lies flat and interferes with smooth travel.
The robot drives and sprays, but the cleaning head lacks its normal scrubbing vibration with a wet pad.
The robot refuses to start and reports two beeps after the two-tone distress sound.
The robot stops or will not proceed and reports one beep after the two-tone distress sound.
The robot will not start, or stops after a pad falls off, and reports three beeps.
The chassis moves beyond a true floor edge instead of backing away.
The robot reports four beeps immediately after an attempted start.
The robot reports ten beeps after the distress sound.
The robot moves, but one wheel makes repeatable noise or feels rough through rotation.
The Clean Base still reports a bag condition after the owner checks the bag.
The clamp lever opens normally, but the installed blade remains trapped in the front clamp.

Failure Modes

part