Search repair guides

Find repair guides, manuals, symptoms, and error codes across the knowledge base.

Models

Roomba S9+

Manuals

IROBOT BRAAVA JET 250 Repair Manual

Symptoms

Water sprays, but the stream is shorter or weaker than normal.
The robot charges fully, but ends early with low battery, repeatedly recharges, or cannot reach the Home Base before Error 46.
The robot runs normally but the charged battery lasts far less than a typical job.
The robot drives and sprays, but the cleaning head lacks its normal scrubbing vibration with a wet pad.
The 200-series robot is awake nearby, but the iRobot app cannot add or connect to it.
The robot moves, but one wheel makes repeatable noise or feels rough through rotation.
The jet pulses irregularly, sprays off-pattern, or carries visible contaminated water.
The correct wet or damp cycle leaves pooling or substantially more water than expected.
The drill runs steadily but drills slowly or cannot drive a normal fastener with correct setup.
The chuck opens and closes, but the bit slips, pulls out, or ejects during normal work.
The robot is charged but cannot drive off the Home Base when a job begins after clearance and placement are proven.
The tank is filled to the top and installed flat, but the red sweep or Error 37 still says to fill it.
Water escapes while filling, carrying, cleaning, or storing the robot.
The clamp lever opens normally, but the installed blade remains trapped in the front clamp.
The blade strokes steadily but cuts slowly, stalls easily, or needs excessive feed force.
The pack will not click into the rear bay or springs loose during handling.
The pad card stops short, binds, or will not remain seated in both underside rails.
The pass count or spray behavior does not match the installed wet, damp, or dry pad.
The same rooms now exhaust a full charge far earlier than the owner baseline.
The robot stops or will not proceed and reports one beep after the two-tone distress sound.

Failure Modes

part