Search repair guides

Find repair guides, manuals, symptoms, and error codes across the knowledge base.

Models

Roomba S9+

Manuals

Symptoms

The shoe will not pivot freely, is bent or loose, or will not sit firmly against the work.
The running saw jumps, vibrates against the work, snags, or kicks backward or sideways.
The collar will not align or hold, or screwdriving clutch cut-off is absent or premature.
The battery will not insert fully, click into place, remain retained, or release normally.
The chuck sleeve will not turn enough to move the jaws or admit a normal straight bit.
The pack will not click into the rear bay or springs loose during handling.
The bit jams, the motor stalls, or the drill twists sharply in the hands during work.
The drill runs steadily but drills slowly or cannot drive a normal fastener with correct setup.
The top lid stands proud, will not latch, or the robot reports Error 45 when a job starts.
The pad card stops short, binds, or will not remain seated in both underside rails.
The robot stops or will not proceed and reports one beep after the two-tone distress sound.
The robot will not start, or stops after a pad falls off, and reports three beeps.
The Clean Base has no status response or cannot pass charge to the robot.
The pack will not charge, or the charger light stays off or shows an abnormal red pattern.
The brush-frame door sits proud, springs open, or will not latch securely.
The charger will not begin or complete charging, or its green light does not behave normally.
The tool-free blade-clamp release lever will not reach full open or close securely.
The corner brush stops, loosens, wobbles, or leaves edge debris behind.
The cool drill begins to run, then stops during a brief no-load test or light work.
The bin will not seat flush, the filter will not stay placed, or detection fails.

Failure Modes

part