Search repair guides

Find repair guides, manuals, symptoms, and error codes across the knowledge base.

Models

Manuals

IROBOT BRAAVA JET 250 Repair Manual

Symptoms

The pad card stops short, binds, or will not remain seated in both underside rails.
The robot will not start, or stops after a pad falls off, and reports three beeps.
The trigger binds, fails to return, starts unpredictably, or no-load speed surges.
The robot drives and sprays, but the cleaning head lacks its normal scrubbing vibration with a wet pad.
The top lid stands proud, will not latch, or the robot reports Error 45 when a job starts.
The bin will not seat flush, the filter will not stay placed, or detection fails.
The robot is charged but cannot drive off the Home Base when a job begins after clearance and placement are proven.
The robot moves, but one wheel makes repeatable noise or feels rough through rotation.
The robot cannot sense or drive the left wheel, announces Error 7, pulls right, or stops at startup.
The robot cannot sense or drive the right wheel, announces Error 10, pulls left, or stops at startup.
The 200-series robot is awake nearby, but the iRobot app cannot add or connect to it.
The pack will not charge, or the charger light stays off or shows an abnormal red pattern.
The battery will not insert fully, click into place, remain retained, or release normally.
The robot charges fully, but ends early with low battery, repeatedly recharges, or cannot reach the Home Base before Error 46.
The tank is filled to the top and installed flat, but the red sweep or Error 37 still says to fill it.
The pad no longer lies flat and interferes with smooth travel.
The robot stops with Error 68 because its camera failed during the cleaning job.
The brush-frame door sits proud, springs open, or will not latch securely.
The Clean Base still reports a bag condition after the owner checks the bag.
The chuck sleeve will not turn enough to move the jaws or admit a normal straight bit.

Failure Modes

part