Search repair guides

Find repair guides, manuals, symptoms, and error codes across the knowledge base.

Models

Manuals

Symptoms

The chuck opens and closes, but the bit slips, pulls out, or ejects during normal work.
The bit jams, the motor stalls, or the drill twists sharply in the hands during work.
The drill runs steadily but drills slowly or cannot drive a normal fastener with correct setup.
The chuck sleeve will not turn enough to move the jaws or admit a normal straight bit.
The cool drill begins to run, then stops during a brief no-load test or light work.
The pack will not charge, or the charger light stays off or shows an abnormal red pattern.
The 200-series robot is awake nearby, but the iRobot app cannot add or connect to it.
The pack will not click into the rear bay or springs loose during handling.
The robot drives and sprays, but the cleaning head lacks its normal scrubbing vibration with a wet pad.
The robot moves, but one wheel makes repeatable noise or feels rough through rotation.
The robot runs normally but the charged battery lasts far less than a typical job.
The clamp lever opens normally, but the installed blade remains trapped in the front clamp.
The robot charges fully, but ends early with low battery, repeatedly recharges, or cannot reach the Home Base before Error 46.
The blade strokes steadily but cuts slowly, stalls easily, or needs excessive feed force.
The Clean Base does not evacuate the bin after self-dock or app command.
The cool saw starts, then stops during a brief no-load test or light cut before heat builds.
The pad no longer lies flat and interferes with smooth travel.
The correct wet or damp cycle leaves pooling or substantially more water than expected.
The robot stops or will not proceed and reports one beep after the two-tone distress sound.
The robot will not start, or stops after a pad falls off, and reports three beeps.

Failure Modes

part