Search repair guides

Find repair guides, manuals, symptoms, and error codes across the knowledge base.

Models

Manuals

Symptoms

After the trigger is released, the blade keeps stroking noticeably longer than normal.
The robot charges fully, but ends early with low battery, repeatedly recharges, or cannot reach the Home Base before Error 46.
The correct wet or damp cycle leaves pooling or substantially more water than expected.
The robot runs normally but the charged battery lasts far less than a typical job.
The pad no longer lies flat and interferes with smooth travel.
The saw, battery, or charger becomes abnormally hot or repeatedly shuts down after warming.
The same rooms now exhaust a full charge far earlier than the owner baseline.
The 200-series robot is awake nearby, but the iRobot app cannot add or connect to it.
The lock-off or trigger sticks, will not move fully, starts unpredictably, or will not stop reliably.
The running saw jumps, vibrates against the work, snags, or kicks backward or sideways.
The robot drives and sprays, but the cleaning head lacks its normal scrubbing vibration with a wet pad.
The robot refuses to start and reports two beeps after the two-tone distress sound.
The robot reports four beeps immediately after an attempted start.
The robot reports ten beeps after the distress sound.
The robot stops or will not proceed and reports one beep after the two-tone distress sound.
The robot will not start, or stops after a pad falls off, and reports three beeps.
The Clean Base has no status response or cannot pass charge to the robot.
The robot moves, but one wheel makes repeatable noise or feels rough through rotation.
The clamp lever opens normally, but the installed blade remains trapped in the front clamp.
The battery will not insert fully, click into place, remain retained, or release normally.

Failure Modes

part