Search repair guides
Find repair guides, manuals, symptoms, and error codes across the knowledge base.
A straight bit stays clamped but rotates off-center, or the chuck body has visible play.
The chuck opens and closes, but the bit slips, pulls out, or ejects during normal work.
The chuck sleeve will not turn enough to move the jaws or admit a normal straight bit.
The drill runs steadily but drills slowly or cannot drive a normal fastener with correct setup.
The pack will not charge, or the charger light stays off or shows an abnormal red pattern.
The two blue-line mode activates, but the robot travels beyond the intended invisible boundary.
The blade strokes steadily but cuts slowly, stalls easily, or needs excessive feed force.
The 200-series robot is awake nearby, but the iRobot app cannot add or connect to it.
The robot moves, but one wheel makes repeatable noise or feels rough through rotation.
The robot drives and sprays, but the cleaning head lacks its normal scrubbing vibration with a wet pad.
The clamp lever opens normally, but the installed blade remains trapped in the front clamp.
The robot charges fully, but ends early with low battery, repeatedly recharges, or cannot reach the Home Base before Error 46.
The robot is charged but cannot drive off the Home Base when a job begins after clearance and placement are proven.
The tank is filled to the top and installed flat, but the red sweep or Error 37 still says to fill it.
The robot repeatedly reverses, circles, turns in place, or drifts instead of following a stable path.
The jet pulses irregularly, sprays off-pattern, or carries visible contaminated water.
The corner brush stops, loosens, wobbles, or leaves edge debris behind.
The Clean Base has no status response or cannot pass charge to the robot.
The cool saw starts, then stops during a brief no-load test or light cut before heat builds.
The robot will not start, or stops after a pad falls off, and reports three beeps.
FM-10: STRAIGHT BIT WOBBLES OR CHUCK IS LOOSE
FM-09: BIT SLIPS OR WILL NOT STAY CLAMPED
FM-08: CHUCK WILL NOT OPEN, CLOSE, OR ACCEPT A BIT
FM-13: CHUCK OR SPINDLE IS HARD TO TURN AT REST
FM-30: THE ROBOT CROSSES THE ONBOARD VIRTUAL WALL BOUNDARY
FM-03: THE BATTERY NEVER REACHES A FULL CHARGE
FM-32: THE CLEAN BUTTON, LIGHTS, OR TONES RESPOND ABNORMALLY
FM-24: THE CLEANING PAD WILL NOT SLIDE INTO THE TRACKS OR LATCH
FM-26: THE ROBOT CHOOSES THE WRONG MOTION OR WETNESS FOR THE PAD
FM-28: THE PAD DRAGS, BUNCHES, SEPARATES, OR RUBS A WHEEL
FM-15: THE ROBOT BACKS UP, TURNS, SPINS, OR WILL NOT TRACK STRAIGHT
FM-06: THE BATTERY WILL NOT LATCH OR STAY SEATED
FM-12: A CORRECT M SERIES PAD IS SEATED BUT NOT DETECTED
FM-19: NO WATER SPRAYS OR THE FLOOR STAYS DRY
FM-22: WATER LEAKS FROM THE CAP OR BODY
FM-03: RUNTIME IS MUCH SHORTER THAN NORMAL
FM-14: A FULL SEATED TANK STILL READS EMPTY
FM-19: THE CORNER BRUSH IS STUCK, LOOSE, OR DOES NOT ROTATE
FM-02: THE CLEAN BASE HAS NO AC POWER OR WILL NOT CHARGE THE ROBOT
FM-12: THE FRONT BUMPER STAYS PRESSED OR REPEATED COLLISIONS CONTINUE