Search repair guides
Find repair guides, manuals, symptoms, and error codes across the knowledge base.
A full-bin indication remains after the bin has been emptied and reinstalled.
The robot drives and sprays, but the cleaning head lacks its normal scrubbing vibration with a wet pad.
The pad card stops short, binds, or will not remain seated in both underside rails.
The robot moves, but one wheel makes repeatable noise or feels rough through rotation.
The bin will not seat flush, the filter will not stay placed, or detection fails.
The pad no longer lies flat and interferes with smooth travel.
The robot refuses to start and reports two beeps after the two-tone distress sound.
The robot stops or will not proceed and reports one beep after the two-tone distress sound.
The robot will not start, or stops after a pad falls off, and reports three beeps.
The 200-series robot is awake nearby, but the iRobot app cannot add or connect to it.
The correct wet or damp cycle leaves pooling or substantially more water than expected.
The robot reports four beeps immediately after an attempted start.
The robot reports ten beeps after the distress sound.
The Clean Base still reports a bag condition after the owner checks the bag.
The Clean Base has no status response or cannot pass charge to the robot.
The bumper remains pressed or collisions repeat after ordinary floor clearing.
The same rooms now exhaust a full charge far earlier than the owner baseline.
The Clean Base does not evacuate the bin after self-dock or app command.
The charger indicates charging but does not reach solid green in the expected charging period.
The Clean Base reports a clog, leaks air, or releases dust from the path.
FM-22: THE FULL BIN INDICATION REMAINS AFTER EMPTYING
FM-15: THE ROBOT BACKS UP, TURNS, SPINS, OR WILL NOT TRACK STRAIGHT
FM-24: THE CLEANING PAD WILL NOT SLIDE INTO THE TRACKS OR LATCH
FM-28: THE PAD DRAGS, BUNCHES, SEPARATES, OR RUBS A WHEEL
FM-03: THE BATTERY NEVER REACHES A FULL CHARGE
FM-25: THE PAD EJECT SLIDER WILL NOT RELEASE THE PAD
FM-06: THE BATTERY WILL NOT LATCH OR STAY SEATED
FM-02: THE WALL CHARGER HAS NO INDICATOR OR POWER
FM-13: THE CLEANING PAD WILL NOT SLIDE IN OR EJECT
FM-21: THE SPRAY SPUTTERS, IS UNEVEN, OR CONTAINS RESIDUE
FM-30: THE ROBOT CROSSES THE ONBOARD VIRTUAL WALL BOUNDARY
FM-26: THE ROBOT CHOOSES THE WRONG MOTION OR WETNESS FOR THE PAD
FM-06: THE ROBOT BACKS UP, SPINS, OR TURNS IN PLACE UNEXPECTEDLY
FM-01: THE ROBOT WILL NOT TURN ON OR WAKE
FM-16: THE LID WILL NOT CLOSE OR THE APP SAYS CLOSE THE LID
FM-14: TWO-TONE DISTRESS SOUND FOLLOWED BY 10 BEEPS
FM-14: A FULL SEATED TANK STILL READS EMPTY
FM-26: THE CLEAN BASE REPORTS A FULL OR MISSING BAG AFTER THE BAG IS CHECKED
FM-02: THE CLEAN BASE HAS NO AC POWER OR WILL NOT CHARGE THE ROBOT
FM-05: THE BATTERY IS NOT DETECTED, NOT COMMUNICATING, OR A BATTERY FAULT REMAINS
Bin, filter, and Full Bin sensors
Vibrating cleaning head
Front and rear cliff sensors
Left and right drive wheels
Pad tracks and attachment card
Rear battery bay and latch
FM-09
FM-24
Front bumper
Genuine tank or cap item
Known live outlet
Drive-wheel module
Drill bit
Clean Base, bag, tube, and ports
Dual rubber brush set
Disposal bag