搜索维修指南
在知识库中查找维修指南、手册、症状和错误代码。
安装了正确的battery，但按下锁定按钮时触发器无motor响应。
已安装充电电池组，但触发器无工作灯、motor声音或冲击锤动作。
The motor can be heard, but the front output remains still in both directions with the bit removed.
WORKLIGHT COMES ON, BUT THE MOTOR WILL NOT START
The external structure is visibly cracked, loose, crushed, melted, or missing material even if the saw still runs.
Pemicu menyalakan area kerja, tetapi motor tetap diam dan landasan tidak bergerak.
battery无法完全滑入手柄、锁定、保持或正常释放。
Tool or battery becomes abnormally hot, smells hot, or repeats heat shutdown after light use.
Narzędzie, akumulator lub ładowarka nagrzewa się nadmiernie lub ochrona wielokrotnie zatrzymuje pracę.
BATTERY WILL NOT CHARGE
Pakiet nie ładuje się lub lampka ładowarki pozostaje wyłączona lub pokazuje nienormalny czerwony wzór.
THE BATTERY WILL NOT SEAT, LATCH, RELEASE, OR STAY SECURE
锯或齿轮箱异常发热或有热味但无烟无火花
The trigger returns normally and power drops, but the anvil repeatedly coasts instead of stopping promptly.
A straight bit traces a visible circle at no load instead of rotating on a stable centerline.
Unit shuts off abruptly
Charger green LED stays on
360度除尘口卡住或松动，或兼容的软管/接头无法保持连接。
Motosega morta con pacco carico
The saw cuts slowly, makes fine dust instead of chips, chatters in the kerf, or must be pushed hard despite judging sharpness.
FM-08: FM-08 链条松弛、下垂或无法保持张力
FM-01: 无 LED 或 motor 响应 通过 FM-01 验证充电、电池安装、中心锁位置、触点和触发器
FM-06: MOTOR运转但刀片不转
FM-05: FM-05 SPEED WILL NOT VARY, SURGES, OR CUTS ERRATICALLY
FM-07: FM-07: A compatible pack stops on the rails, will not reach full
FM-15: FM-15 工具或BATTERY过热或反复关机
FM-04: FM-04 运行时间非常短或工具突然关闭
FM-04: FM-04 工具启动后冷却时断电
FM-11: FM-11 刹车无法快速停止输出
FM-16: FM-16 立即BATTERY、充电器、液体或结构危险
FM-05: FM-05 触发器卡滞或速度控制不安全
FM-05: 如果锯子在确认有电且控制自由的情况下仍无反应，保持机壳关闭，
FM-32: Røyk kommer ut av verktøyet under drift
FM-34: Materialfjerning forblir treg ved høy hastighet
FM-10: FM-10 紧固输出弱或无冲击动作
FM-04: FM-04 钻机冷却时断电
FM-03: The Saw Starts, Then Cuts Out With The Trigger Held
FM-16: FM-16 立即BATTERY、充电器或工具危险
FM-11: FM-11 速度或扭矩在正确设置下偏低
FM-12: FM-12 钻头卡滞、卡死或扭转钻机