FM-03: 锯子启动后，扳机保持按下时断电

锯启动后，触发器保持按下时停止工作，无论负载与否。

• Pack protection opened for charge or temperature
• Blade was pinched, bound, or overloaded by the cut
• Pack is loose or the contacts are intermittent under vibration
• Blocked vents or heavy loading caused thermal protection
• Internal control or motor fault

1. The saw runs steadily at no load and through a controlled supported cut.

1. Release the trigger and wait until the blade stops completely.
2. Remove the battery, free the saw from the work, and clear any pinching or blocked vents.
3. Install a charged known-good pack and run the saw briefly at no load.
4. - If no-load cutout repeats, keep the saw out of service - if stable, correct blade, support, and feed.

这是完整维修手册中所含故障排除指南的预览。

• Motor、齿轮箱或主轴
• FLEXVOLT battery 接口
• 电子 module 和 motor
• 兼容FLEXVOLT battery

• 锯子启动后，扳机保持按下时断电

  锯启动后，触发器保持按下时停止工作，无论负载与否。

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。