Category: Power Tools

Brand: BLACK+DECKER

Model: LCS1020

מדריך תיקון BLACK+DECKER LCS1020

מדריך תיקון מקיף למסור השרשרת האלחוטי BLACK+DECKER LCS1020, כולל פתרון בעיות, תחזוקה והוראות תיקון ל-24 תקלות נפוצות.

$39.99

Last updated Aug 22, 2026, 10:05 AM

About this manual

מדריך תיקון מקיף למסור השרשרת האלחוטי BLACK+DECKER LCS1020, כולל פתרון בעיות, תחזוקה והוראות תיקון ל-24 תקלות נפוצות.

0% Reported Successful Repair

Price

$39.99

Full Manual Includes

root cause analysis
tools needed
step-by-step repair procedure
diagrams
exploded views
post-repair checks

Table of contents preview

Black+decker Lcs1020
שש הדברים החשובים ביותר
מה יש בדגם זה בפועל
מפת אינדיקטורים ואותות
אזהרת גרסת דגם
נתיב החיתוך
רצף שימוש רגיל
התנהגות רגילה שיכולה להיראות כתקלה
מה אין בדגם זה
המסור
לא ניתן להשתמש בו
FM-08 השרשרת רפויה, שקועה, או לא שומרת על מתיחה
FM-20 רעש חריג, רעידות, או ויברציה חמורה
FM-09 השרשרת מתוחה מדי, נתקעת ביד, או שהמוט והשרשרת מתחממים
FM-21 מוט, שרשרת מסור, נרתיק, או אביזר חיתוך פגומים

This preview shows only a portion of the complete repair manual. Purchase to access the full repair documentation, downloadable PDF and detailed repair procedures.

Supported model

View model troubleshooting page

BLACK+DECKER

Bdcr20c

View details

BLACK+DECKER

Bdcdd12c

View details

BLACK+DECKER

Ld120va

View details

BLACK+DECKER

Bdci20c

View details

The battery will not slide fully into the tool, click into place, stay latched, or release normally.

View details

The chain travels around the bar but only rubs the wood, produces almost no chips, and will not enter the cut.

View details

The saw chain leaves the guide-bar groove, hangs from the bar, or comes off the drive sprocket.

View details

Bar oil forms a fresh puddle, runs from the cap, or appears from the body while the saw is idle or stored.

View details

The cap will not close, the primer is split or stuck, or the oil-level indicator is cracked, clouded, or leaking.

View details

The saw cuts slowly, makes fine dust instead of chips, chatters in the kerf, or must be pushed hard despite judging sharpness.

View details

The lock-off or trigger will not move freely, does not return, responds intermittently, or the motor continues after the trigger is released.

View details

The reservoir contains oil but the chain stays dry, the primer gives no visible result, or the bar oil path remains dry.

View details

Saw dead with charged pack

View details

The saw makes new grinding, clacking, rattling, or strong vibration during no-load running or cutting.

View details

After chain or bar work, the cover will not sit flush, the bar will not align, or the locking knob cannot begin correctly.

View details

The bar is bent or cracked, chain links or cutters are broken, or the guide-bar scabbard is split, missing, or will not stay on.

View details

Motor runs, chain does not

View details

The guide bar steers sideways in the cut or the kerf curves even though the workpiece is supported and the saw is held square.

View details

Chain moves but does not cut

View details

The guide bar cannot be withdrawn from the kerf, the chain is trapped, or the workpiece closes on the saw.

View details

The lithium battery or charger shows abnormal heat, swelling, cracking, electrolyte, hissing, odor, sparks, or smoke.

View details

The chain hangs below the guide bar, can be pulled too far from the rail, or becomes loose again after adjustment.

View details

Liquid entered the tool, the housing emits smoke or sparks, plastic melts, a burning odor appears, or wiring or contacts are exposed.

View details

The chain is hard to pull around the bar, the bar becomes unusually hot, or smoke appears without an electrical odor.

View details

The front hand guard, front or rear handle, main housing, ribbed bumper, fastener, battery well, or another external part is cracked, loose, or missing.

View details

A tool-free knob is frozen, cross-threaded, spins without effect, will not clamp the bar, or cannot hold the set tension.

View details

The motor can be heard, but the chain remains stationary or only twitches while the trigger is held.

View details

FM-01: FM-01 חבילת BATTERY לא תיכנס, לא תינעל או לא תשוחרר

Summary

מארז Battery לא נכנס, לא ננעל או לא משתחרר כראוי, ומונע הפעלת הכלי.

Full repair guide includes

Root Cause Analysis
Required Tools
Replacement Parts
Step-by-step Repair Procedure
Safety Precautions
Verification Checklist

מדריך תיקון BLACK+DECKER LCS1020

Manual information

About this manual

Full Manual Includes

Table of contents preview

Supported model

Related Models

Common Symptoms

Failure Modes

Related Manuals