Symptômes
Parcourez les symptômes documentés et accédez aux guides de réparation correspondants depuis les résultats de recherche.
The robot stops with Error 68 because its camera failed during the cleaning job.
0 manuel associé
Trouver des guides →
The drill runs steadily but drills slowly or cannot drive a normal fastener with correct setup.
0 manuel associé
Trouver des guides →
The robot reports four beeps immediately after an attempted start.
0 manuel associé
Trouver des guides →
The app reports Error 21, 25, 34, 38, 39, 47, 66, or 76 and the robot cannot reliably continue.
0 manuel associé
Trouver des guides →
The robot stops and reports five beeps while wedged or unable to escape.
0 manuel associé
Trouver des guides →
The bit jams, the motor stalls, or the drill twists sharply in the hands during work.
0 manuel associé
Trouver des guides →
The running saw jumps, vibrates against the work, snags, or kicks backward or sideways.
0 manuel associé
Trouver des guides →
A genuine m Series pad is fully seated in both tracks, but the robot refuses to run or selects the wrong pad state.
0 manuel associé
Trouver des guides →
With the battery removed and no bit fitted, the chuck will not hand-turn normally or feels seized.
0 manuel associé
Trouver des guides →
After the trigger is released, the blade keeps stroking noticeably longer than normal.
0 manuel associé
Trouver des guides →
The robot stops with a drive wheel hanging over a step or threshold and reports six beeps.
0 manuel associé
Trouver des guides →
With a secure known-good blade clear of the work, the saw has harsh sound, bind, or vibration.
0 manuel associé
Trouver des guides →
The robot stops and reports eight beeps because its wheels cannot turn.
0 manuel associé
Trouver des guides →
A secure straight bit and clear work do not eliminate harsh no-load sound or vibration.
0 manuel associé
Trouver des guides →
A correct m Series pad binds in the tracks, will not seat flat, or will not release when the eject button is pressed.
0 manuel associé
Trouver des guides →
The robot reports ten beeps after the distress sound.
0 manuel associé
Trouver des guides →
The tool, pack, or charger becomes unusually hot, or protection repeatedly stops operation.
0 manuel associé
Trouver des guides →
The tank is filled to the top and installed flat, but the red sweep or Error 37 still says to fill it.
0 manuel associé
Trouver des guides →
The saw, battery, or charger becomes abnormally hot or repeatedly shuts down after warming.
0 manuel associé
Trouver des guides →
The robot repeatedly reverses, circles, turns in place, or drifts instead of following a stable path.
0 manuel associé
Trouver des guides →