FM-23: 切割深度无法设置、锁定、保持或达到正常范围

底板无法滑动至所需锯片露出深度，深度杆无法夹紧，切割时深度变化，或正确锯片时最大深度明显不足。

• Sawdust is packed at the depth guide, lever, or shoe slide
• Depth lever is loose, stripped, cracked, or incorrectly adjusted
• Shoe, depth guide, or guard is bent or obstructed

1. The depth moves freely, locks without slip, repeats the chosen exposure, and allows the specified normal range with the correct blade.

1. Remove the battery, loosen the depth lever, and clear exposed dry sawdust from the depth guide, lever, and shoe movement path.
2. Confirm the correct blade is centered and clamped, and inspect the shoe, guide, lever, and lower guard for bend, crack, interference, or missing hardware.
3. Move the shoe to expose about one-half tooth below the intended material and retighten the lever in the official direction before cutting.
4. - Check that the setting does not move by hand and that normal travel includes up to 2-9/16 inches at 90 degrees with the correct blade - if not, use authoriz

这是完整维修手册中所含故障排除指南的预览。

• 深度杠杆、导向及刻度
• 底板及结构枢轴
• 下护罩、缩回杠杆、枢轴及弹簧
• 7-1/4英寸木工锯片

• 切割深度无法设置、锁定、保持或达到正常范围

  底板无法滑动至所需锯片露出深度，深度杆无法夹紧，切割时深度变化，或正确锯片时最大深度明显不足。

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。