FM-21: 零度切割未垂直于材料表面

斜角指针设为零且底板看似平放，但完成的切割始终不与工件表面成90度。

• Zero-degree shoe calibration is out of adjustment
• Bevel lever is not fully locked or shoe moves during the cut
• Blade is bent, loose, or side-loaded
• Shoe is bent, dirty, or not resting flat on the work

1. An actual zero-bevel scrap cut measures square through the material and the locked setting repeats.

1. Release the trigger, wait for a full stop, remove the battery, set bevel to zero, and clean the shoe/blade reference surfaces.
2. Confirm a straight correctly clamped blade, a flat undamaged shoe, and a bevel lever that locks without movement.
3. Retract the lower guard with the battery removed, place the saw on its blade side, and compare the blade plate - not a tooth - to an accurate square agains
4. Adjust only the accessible 90-degree calibration screw by the official procedure, relock the bevel lever, and return the guard to normal operation.
5. - Make and square-check an actual supported scrap cut - if the setting will not calibrate or hold, stop and route the shoe, quadrant, pivot, and spindle align

这是完整维修手册中所含故障排除指南的预览。

• 斜角杠杆、象限、指针及零点校准
• 底板及结构枢轴
• 下护罩、缩回杠杆、枢轴及弹簧
• 齿轮箱、齿轮、轴承或主轴
• 齿轮箱、齿轮、轴承及主轴
• 7-1/4英寸木工锯片

• 零度切割未垂直于材料表面

  斜角指针设为零且底板看似平放，但完成的切割始终不与工件表面成90度。

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。