FM-18: 锯片卡滞、夹紧、夹紧或锯在切割时反冲

锯片被切缝物理卡住或减速，锯向操作员方向抬起或反冲，或尝试在锯齿卡入材料时重新启动。

• Workpiece is supported so the kerf closes and pinches the blade
• Blade is dull, dirty, bent, wrong, too deep, or twisted off the line
• Saw was started against the work or forced, turned, or backed in the cut
• Wet, knotty, treated, or unstable wood is loading the blade

1. The saw enters at full speed and completes a supported straight scrap cut without kerf closure, stall, twist, lift, or kickback.

1. Release the trigger immediately, hold the saw firmly until the blade stops and guard closes, then remove the battery before freeing the blade.
2. Support the work close to the cut so the cutoff cannot sag into the kerf, and remove nails, wire, unstable pieces, and binding forces.
3. - Inspect and replace a dull, dirty, bent, damaged, or wrong blade - set depth to about one-half tooth below the material and secure both adjustment levers.
4. Reposition the shoe flat and straight, bring the blade to full speed before contact, and feed at a rate that lets the blade cut without laboring or turning
5. - Make one supported scrap cut - if binding occurs with correct support, blade, depth, alignment, and feed, stop and route guard, shoe, spindle, and drive ali

这是完整维修手册中所含故障排除指南的预览。

• 斜角杠杆、象限、指针及零点校准
• 底板及结构枢轴
• 木工圆锯片
• 主手柄、辅助手柄及保护结构
• 深度杠杆、导向及刻度
• 齿轮箱、齿轮、轴承或主轴
• 下护罩、缩回杠杆、枢轴及弹簧
• 齿轮箱、齿轮、轴承及主轴
• 7-1/4英寸木工锯片

• 锯片卡滞、夹紧、夹紧或锯在切割时反冲

  锯片被切缝物理卡住或减速，锯向操作员方向抬起或反冲，或尝试在锯齿卡入材料时重新启动。

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。