FM-16: 安装的锯片松动、晃动、打滑或偏心运行

安装后锯片在主轴处可移动，明显左右晃动，负载下打滑，或即使 motor 旋转也无法保持居中。

• Wrong arbor size, blade diameter, blade type, or damaged blade plate
• Outer washer is reversed, missing, dirty, or not seated
• Clamping screw is loose or clamp/spindle surfaces are damaged
• Blade is bent, cracked, or mounted in the wrong rotation direction

1. With the battery removed, the blade is rigid at the spindle, rotates by hand without lateral runout or guard contact, and remains secure in one controlled cut.

1. Release the trigger at the first wobble or slip, wait for a full stop, remove the battery, and do not make another powered cut.
2. Remove the blade and reject any bent, cracked, chipped, wrong-size, wrong-arbor, abrasive, or unsuitable blade.
3. Clean the spindle and clamp area dry, inspect both washers and the clamping screw, and confirm the large flat washer face is against the blade with the bev
4. Install a verified correct blade in the marked rotation direction and tighten firmly using the blade-lock and wrench procedure.
5. - Hand-turn and visually check clearance and runout - if looseness, slip, or off-center rotation remains, stop and route the spindle/clamp system for authoriz

这是完整维修手册中所含故障排除指南的预览。

• 木工圆锯片
• 刀片夹紧screw或垫圈
• 齿轮箱、齿轮、轴承或主轴
• 锯片锁、锯片扳手、夹紧screw及垫圈
• 下护罩、缩回杠杆、枢轴及弹簧
• 齿轮箱、齿轮、轴承及主轴
• 7-1/4英寸木工锯片

• 安装的锯片松动、晃动、打滑或偏心运行

  安装后锯片在主轴处可移动，明显左右晃动，负载下打滑，或即使 motor 旋转也无法保持居中。

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。