FM-10: Motor 停止但电刹车不再减少锯片惯性旋转

释放扳机时motor声音停止，但锯片惯性旋转时间明显长于之前。

• Electric-brake control or motor feedback has failed
• Battery connection is intermittent during deceleration
• Blade, washer, or spindle condition is affecting coast behavior
• Expectation is based on an instant stop rather than a measurable change from normal operation

1. The product has an electric brake, but no owner procedure establishes an exact stop time. Always wait for a complete stop and guard closure regardless of brake behavior. Trigger release ends motor power and the repaired brake consistently shortens blade coast without noise, runout, or guard contact.

1. - Keep the shoe supported and hands on the handles until the blade stops completely and the lower guard closes - do not set the saw down during the coast.
2. Remove the battery and verify that the blade, clamp washer, screw, and lower guard are correctly assembled and free of visible damage or drag.
3. Fit a known-good fully charged compatible pack and make several clear no-load stop comparisons without contacting wood.
4. If the motor command ends but braking is consistently absent compared with the saw's established normal behavior, stop use and request authorized brake, mo

这是完整维修手册中所含故障排除指南的预览。

• 齿轮箱、齿轮、轴承及主轴
• 7-1/4英寸木工锯片
• 下护罩、缩回杠杆、枢轴及弹簧
• 电子module或无刷motor
• 电子module、无刷motor及电动制动

• Motor 停止但电刹车不再减少锯片惯性旋转

  释放扳机时motor声音停止，但锯片惯性旋转时间明显长于之前。

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。