FM-02: 锯子启动后负载下突然关闭

锯片达到转速，进入木材后，所有动力旋转突然停止，而非仅仅减速或在锯缝中卡住。

• Electronic protection responded to overload, temperature, or deep battery discharge
• Battery is weak, undercharged, too hot, too cold, or moving on the rails
• Blade, depth, feed rate, or work support is creating excessive load
• Blocked vents or an internal electronic or motor fault repeats under load

1. The saw completes a controlled supported cut without abrupt powered shutdown, abnormal heat, or battery movement.

1. Release the trigger, hold the shoe still until the blade stops and the lower guard closes, then remove the battery before freeing the saw.
2. Let the tool and pack cool in a dry ventilated place, and inspect for heat damage, liquid, smoke, sparks, or a battery hazard before any retest.
3. Free the blade from the kerf, correct work support and cutting depth, clean the vents dry, and replace a dull, damaged, dirty, or wrong blade.
4. Install a known-good fully charged compatible pack and make one controlled light cut in supported scrap without forcing the saw.
5. If the powered shutdown repeats while the blade remains free and the proven pack, blade, depth, support, and feed are correct, stop use and route the saw f

这是完整维修手册中所含故障排除指南的预览。

• 深度杠杆、导向及刻度
• 冷却通风口及外壳
• 7-1/4英寸木工锯片
• 电子module、无刷motor及电动制动
• Battery导轨、触点、锁扣及释放机构
• 电子module或无刷motor
• FLEXVOLT battery 电池组

• 锯子启动后负载下突然关闭

  锯片达到转速，进入木材后，所有动力旋转突然停止，而非仅仅减速或在锯缝中卡住。

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。