FM-05: 锯在负载下关闭或断续切割

FM-05 锯在负载下关闭或断续切割

• Electronic protection stopped overload, heat, or deep discharge
• Battery latch or contacts are intermittent
• Battery is weak or not fully charged
• Blade is dull, pinched, or set too deep
• Switch, motor, wiring, or gear train is failing

1. The saw maintains steady power through a supported test cut without contact movement, overload shutdown, or intermittent stopping.

1. Inspect for a sharp correct blade, one-tooth depth, tight depth and bevel locks, and work support that keeps the kerf from closing on the blade.
2. Test a known-good battery on supported scrap with gentle feed; if cutouts repeat after load and fit are corrected, stop and service the switch, motor, wiring, or gear train.
3. Release the trigger, hold the saw still until the blade stops, remove the battery, and let both tool and pack cool before inspection.
4. Check the battery latch and contacts, clear the cooling vents dry, and fully charge the battery; use FM-15 for a pack that moves or will not latch.

这是完整维修手册中所含故障排除指南的预览。

• Saw cuts out under load

  Saw cuts out under load Electronic protection, weak pack, intermittent contact, overload, or internal fault; use FM-05.

• The saw starts normally but stops, pulses, or loses power during a cut, especially when pushed or when the battery is moved.

  The saw starts normally but stops, pulses, or loses power 1. Release the trigger, hold the saw still until the blade stops, remove the battery, and let

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。