FM-09: 锯反冲、爬升或后退

锯出现反冲行为：突然抬起、向操作者跳跃、从锯缝爬出或因刀片夹紧或扭曲而后退。

• Kerf closes on the blade from poor support
• Blade is dull, damaged, or misaligned
• Saw is twisted or restarted with teeth engaged
• Depth or bevel lock shifted
• Operator is behind the blade line or pulling backward

1. A properly supported test cut tracks forward without pinch, climb, backward motion, or shifting adjustments.

1. Remove the battery and identify the pinch or twist: check panel support, kerf closure, blade condition, blade seating, and tight depth and bevel locks.
2. Correct support on both sides near the cut, set one-tooth depth, fit a sharp correct blade, and center the blade in the kerf before any restart.
3. Make a fresh controlled test with both hands and your body to one side of the blade; repeat kickback means stop use and qualified inspection.
4. Release the trigger and hold the saw motionless in the material until the blade completely stops; never pull the saw backward while the blade moves.

这是完整维修手册中所含故障排除指南的预览。

• 斜切旋钮、刻度、枢轴和90度对齐

• The saw suddenly lifts, jumps toward the operator, climbs out of the kerf, or walks backward as the blade pinches or twists.

  The saw suddenly lifts, jumps toward the operator, climbs out of the kerf, or Release the trigger and hold the saw motionless in the material until the blade completely FM-09

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。