FM-10: 切割不方正或斜切角度不準確

FM-10 切割不方正或斜切角度不準確

• Blade is loose, warped, or not seated
• Shoe is not square to the blade at zero
• Bevel scale or 90-degree alignment needs calibration
• Shoe is bent or work support is uneven
• Guide technique or blade choice causes wandering

1. A measured scrap cut matches the selected 0-degree or bevel setting and the shoe remains locked.

1. Set the desired bevel from the scale, tighten the bevel knob, set and lock depth, and use a marked line, fence, or straightedge on supported work.
2. Make and measure a scrap cut; if calibration cannot be achieved or the blade wanders with sound setup, service the shoe, spindle, or bearing.
3. Remove the battery, set the bevel to zero, and place a square between the shoe and blade body while avoiding the carbide teeth.
4. Confirm the blade, washer, and bolt are seated and secure, and inspect the shoe for bending; use the manual 90-degree alignment procedure only when needed.

这是完整维修手册中所含故障排除指南的预览。

• 鋸完成切割，但0度切割不方正，斜切角度與刻度不符，或切口偏離預期角度。

  鋸子完成切割，但 0 度切割不方正， 1. 拆除 battery，將斜角設為零，並將方尺放在鞋子和鋸片本體之間，避開硬質合金齒。

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。