FM-08: 切割慢、卡住、停轉、燒焦或碎裂

切割性能問題，鋸片轉動但鋸進差、卡住、燒焦木材或過度碎裂。建議立即停止使用以防損壞或受傷。

• Blade is dull, damaged, dirty, or wrong for wood
• Cut depth is excessive
• Kerf closes because the work is unsupported
• Depth or bevel lock is loose
• Saw is forced before full speed or against the cut line

1. The saw advances smoothly through supported wood with a clean kerf, normal motor sound, and no burning, stall, or excessive splintering.

1. Set depth so about one tooth projects below the work, lock depth and bevel, and support and clamp the work so the kerf cannot close on the blade.
2. Let the blade reach full speed, keep the shoe flat, and guide with gentle pressure on scrap; persistent overload or poor cutting routes to FM-05 or FM-07.
3. Release the trigger, hold the saw still until the blade stops, remove it from the cut only after the stop, and remove the battery.
4. Fit a clean sharp wood-cutting blade of the correct diameter, bore, and speed rating; remove sap buildup and reject damaged or abrasive wheels.

这是完整维修手册中所含故障排除指南的预览。

• 鋸片、外墊圈同左旋bolt
• 鋸鞋、深度桿同深度刻度

• The blade turns, but the saw feeds poorly, stalls in the kerf, burns the wood, splinters excessively, or overloads during an ordinary cut.

  The blade turns, but the saw feeds poorly, stalls in the kerf, burns the wood, Release the trigger, hold the saw still until the blade stops, remove it from the cut only after FM-08

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。