FM-01: 電鑽/起子喺驗證過嘅 BATTERY 下唔會啟動

即使裝咗驗證過、充滿電嘅 V20 battery，電鑽/起子都唔會啟動，方向按鈕完全前或後。冇 motor 聲音、LED 活動或夾頭動作，工具無反應。

• Battery is discharged, temperature-protected, or internally failed
• Battery contacts are dirty or the pack is not fully seated on the rails
• Forward/reverse button is centered or not fully in a drive detent
• Trigger, contact block, wiring, brushes, motor, or switch has failed

1. lock, or perform live internal tests.

1. Push the direction button fully forward or reverse and make one controlled no-load trigger test with the chuck empty.
2. Cross-test the battery in a known-good V20 tool or approved charger, and replace only a pack that fails reciprocal testing.
3. If a proven battery still gives persistent zero response, remove it and route the sealed trigger, contact block, brush, motor, or wiring path to qualified service.
4. Center the direction button, remove the battery, and inspect the tool and pack for liquid, swelling, cracks, melting, or burning.
5. Dry-clean the accessible battery and tool contacts, then slide in a room-temperature fully charged V20 battery until the latch clicks.

这是完整维修手册中所含故障排除指南的预览。

• 一個正常嘅V20 battery完全就位，方向掣完全前推或後推，工具冇motor聲、LED反應或夾頭動作。死機狀態喺工具靜止時持續。

  一個正常嘅V20 battery完全插好，方向掣完全 1. 將方向掣置中，移除battery，並檢查工具同電池包有冇液體、膨脹、裂紋、熔化或燒焦。

• 電鑽/起子喺驗證過嘅 BATTERY 下唔會啟動

  FM-01 電鑽/起子喺驗證過嘅 FM-09 BATTERY 運行時間遠短於預期

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。