A Serra Ou Battery Superaquece Ou Desligamento Por Calor Se Repete

A serra ou o pacote aquece anormalmente, perde potência ou para durante um corte suportado.

• Vents are blocked by sawdust or the saw is covered
• Blade is dull or the feed load is excessive
• Battery is hot, cold, low, damaged, or unsuitable
• Cut depth, support, or material is overloading the saw
• Motor, bearing, controller, or battery fault

1. A light supported cut completes without abnormal heat or shutdown.

1. Release trigger, remove pack, and place both on a clear surface.
2. Let saw and pack cool naturally, then brush the vents and inspect for damage or odor.
3. - Fit sharp blade and good pack - correct depth and support - test lightly.
4. If abnormal heat or shutdown returns, stop use and seek qualified service.

Esta é uma prévia da orientação de solução de problemas incluída no manual de reparo completo.

• FM-14: Fm Dcs575 14

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

As páginas públicas mostram apenas uma prévia. Compre o manual completo para baixar as etapas de reparo, diagramas e procedimentos de verificação completos.