A Serra Não Liga Ou Não Responde

- Pressionar bloqueio e gatilho não produz movimento do motor - a luz de trabalho pode permanecer apagada.

• Battery pack is discharged, too hot or cold, or faulty
• Pack is not fully seated or its contacts are obstructed
• Trigger lock-off button is not fully released or is damaged
• Trigger movement is blocked or damaged
• Internal switch, controller, or motor fault

1. The saw starts normally with a latched known-good pack.

1. Release the trigger, remove the battery, and let all blade motion stop.
2. Inspect the battery rails, contacts, lock-off, and trigger for damage or loose dry debris.
3. Install a charged known-good compatible pack until it latches, then press lock-off and pull the trigger.
4. - Test at no load - if motor, blade, and worklight stay dead, keep the saw out of service.

Esta é uma prévia da orientação de solução de problemas incluída no manual de reparo completo.

• FM-01: Fm Dcs575 01

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

As páginas públicas mostram apenas uma prévia. Compre o manual completo para baixar as etapas de reparo, diagramas e procedimentos de verificação completos.