A Serra Liga, Mas Desliga Com O Gatilho Preso

A serra liga, depois para enquanto o gatilho permanece pressionado, sob carga ou sem carga.

• Pack protection opened for charge or temperature
• Blade was pinched, bound, or overloaded by the cut
• Pack is loose or the contacts are intermittent under vibration
• Blocked vents or heavy loading caused thermal protection
• Internal control or motor fault

1. The saw runs steadily at no load and through a controlled supported cut.

1. Release the trigger and wait until the blade stops completely.
2. Remove the battery, free the saw from the work, and clear any pinching or blocked vents.
3. Install a charged known-good pack and run the saw briefly at no load.
4. - If no-load cutout repeats, keep the saw out of service - if stable, correct blade, support, and feed.

Esta é uma prévia da orientação de solução de problemas incluída no manual de reparo completo.

• FM-03: Fm Dcs575 03

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

As páginas públicas mostram apenas uma prévia. Compre o manual completo para baixar as etapas de reparo, diagramas e procedimentos de verificação completos.