A Lâmina Trava, Para Ou A Serra Sofre Recuo

A lâmina prende, para no corte, sobe ou pula, ou não pode reiniciar com segurança.

• Workpiece support lets the kerf close on the blade
• Blade is dull, damaged, dirty, or installed incorrectly
• Depth or bevel lever is loose or set incorrectly
• Saw is twisted, forced, or restarted in the kerf
• Fastener, knot, or offcut pinches the blade

1. The saw completes a supported cut without binding, stalling, or kickback.

1. Release the trigger and hold the saw still in the kerf.
2. Wait for a complete stop, remove the battery, then free and support the workpiece correctly.
3. Check blade condition, direction, depth, bevel locks, and the cut path for obstructions.
4. Restart only with the blade centered and teeth clear, then verify a controlled supported cut.

Esta é uma prévia da orientação de solução de problemas incluída no manual de reparo completo.

• FM-12: Fm Dcs575 12

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

As páginas públicas mostram apenas uma prévia. Compre o manual completo para baixar as etapas de reparo, diagramas e procedimentos de verificação completos.