failure mode
FM-12: A Lâmina Trava, Para Ou A Serra Sofre Recuo
A lâmina prende, para no corte, sobe ou pula, ou não pode reiniciar com segurança.
Visão geral do diagnóstico
A lâmina prende, para no corte, sobe ou pula, ou não pode reiniciar com segurança.
Causas prováveis
- Workpiece support lets the kerf close on the blade
- Blade is dull, damaged, dirty, or installed incorrectly
- Depth or bevel lever is loose or set incorrectly
- Saw is twisted, forced, or restarted in the kerf
- Fastener, knot, or offcut pinches the blade
Verificações rápidas
- The saw completes a supported cut without binding, stalling, or kickback.
Prévia de reparo
- Release the trigger and hold the saw still in the kerf.
- Wait for a complete stop, remove the battery, then free and support the workpiece correctly.
- Check blade condition, direction, depth, bevel locks, and the cut path for obstructions.
- Restart only with the blade centered and teeth clear, then verify a controlled supported cut.
Esta é uma prévia da orientação de solução de problemas incluída no manual de reparo completo.
Correções comuns
- Alavanca de bisel e quadrante
- Guia de corte e ranhura do guia paralelo
- Alavanca de profundidade e sapata
- Conjunto de profundidade, bisel ou sapata
- Lâmina de serra circular
Sintomas relacionados
A Lâmina Trava, Para Ou A Serra Sofre Recuo
A lâmina prende, para no corte, sobe ou pula, ou não pode reiniciar com segurança.
Incluído no manual completo
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
As páginas públicas mostram apenas uma prévia. Compre o manual completo para baixar as etapas de reparo, diagramas e procedimentos de verificação completos.