failure mode
FM-03: A Serra Liga, Mas Desliga Com O Gatilho Preso
A serra liga, depois para enquanto o gatilho permanece pressionado, sob carga ou sem carga.
Visão geral do diagnóstico
A serra liga, depois para enquanto o gatilho permanece pressionado, sob carga ou sem carga.
Causas prováveis
- Pack protection opened for charge or temperature
- Blade was pinched, bound, or overloaded by the cut
- Pack is loose or the contacts are intermittent under vibration
- Blocked vents or heavy loading caused thermal protection
- Internal control or motor fault
Verificações rápidas
- The saw runs steadily at no load and through a controlled supported cut.
Prévia de reparo
- Release the trigger and wait until the blade stops completely.
- Remove the battery, free the saw from the work, and clear any pinching or blocked vents.
- Install a charged known-good pack and run the saw briefly at no load.
- - If no-load cutout repeats, keep the saw out of service - if stable, correct blade, support, and feed.
Esta é uma prévia da orientação de solução de problemas incluída no manual de reparo completo.
Correções comuns
- Motor, caixa de engrenagens ou eixo
- Interface do pacote FLEXVOLT battery
- module eletrônico e motor
- Bateria FLEXVOLT battery compatível
Sintomas relacionados
A Serra Liga, Mas Desliga Com O Gatilho Preso
A serra liga, depois para enquanto o gatilho permanece pressionado, sob carga ou sem carga.
Incluído no manual completo
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
As páginas públicas mostram apenas uma prévia. Compre o manual completo para baixar as etapas de reparo, diagramas e procedimentos de verificação completos.