failure mode
FM-08: 블레이드를 제거, 설치 또는 고정할 수 없음
블레이드 잠금이 작동하지 않거나 클램핑 screw가 풀리거나 조여지지 않거나 블레이드와 와셔를 안전하게 조립할 수 없습니다.
진단 개요
블레이드 잠금이 작동하지 않거나 클램핑 screw가 풀리거나 조여지지 않거나 블레이드와 와셔를 안전하게 조립할 수 없습니다.
예상 근본 원인
- Blade lock is not aligned with the spindle
- Wrong direction used on the right-hand screw
- Sawdust packed around clamp washer or spindle
- Spindle lock or threads are damaged internally
빠른 점검
- The correct blade and washers clamp securely with the supplied wrench.
수리 미리보기
- Remove the battery before touching any blade hardware.
- Press the blade lock while turning the spindle by hand until the lock engages.
- - Turn the screw counterclockwise to loosen and clockwise to tighten - clean clamp surfaces dry.
- If the lock, threads, screw, or washers will not secure the blade, stop and seek service.
이것은 전체 수리 매뉴얼에 포함된 문제 해결 안내의 미리보기입니다.
일반적인 수리
- 톱날 screw 및 외부 클램프
- 블레이드 렌치
- 블레이드 잠금 및 블레이드 렌치
- 클램핑 screw 및 와셔
- 원형 톱날
- 스핀들, 기어케이스 및 블레이드
- Motor, 기어케이스 또는 스핀들
관련 증상
블레이드를 제거, 설치 또는 고정할 수 없음
블레이드 잠금이 작동하지 않거나 클램핑 screw가 풀리거나 조여지지 않거나 블레이드와 와셔를 안전하게 조립할 수 없습니다.
전체 매뉴얼에 포함
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
공개 페이지에는 미리보기만 표시됩니다. 전체 수리 단계, 다이어그램 및 검증 절차를 다운로드하려면 전체 매뉴얼을 구매하세요.