failure mode
FM-03: 톱이 시작되었다가 트리거를 누른 상태에서 차단됨
톱이 시작되었다가 트리거를 누른 상태에서 부하 또는 무부하 상태에서 멈춥니다.
진단 개요
톱이 시작되었다가 트리거를 누른 상태에서 부하 또는 무부하 상태에서 멈춥니다.
예상 근본 원인
- Pack protection opened for charge or temperature
- Blade was pinched, bound, or overloaded by the cut
- Pack is loose or the contacts are intermittent under vibration
- Blocked vents or heavy loading caused thermal protection
- Internal control or motor fault
빠른 점검
- The saw runs steadily at no load and through a controlled supported cut.
수리 미리보기
- Release the trigger and wait until the blade stops completely.
- Remove the battery, free the saw from the work, and clear any pinching or blocked vents.
- Install a charged known-good pack and run the saw briefly at no load.
- - If no-load cutout repeats, keep the saw out of service - if stable, correct blade, support, and feed.
이것은 전체 수리 매뉴얼에 포함된 문제 해결 안내의 미리보기입니다.
일반적인 수리
- Motor, 기어케이스 또는 스핀들
- FLEXVOLT battery 인터페이스
- 전자 module 및 motor
- 호환 가능한 FLEXVOLT battery
관련 증상
톱이 시작되었다가 트리거를 누른 상태에서 차단됨
톱이 시작되었다가 트리거를 누른 상태에서 부하 또는 무부하 상태에서 멈춥니다.
전체 매뉴얼에 포함
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
공개 페이지에는 미리보기만 표시됩니다. 전체 수리 단계, 다이어그램 및 검증 절차를 다운로드하려면 전체 매뉴얼을 구매하세요.