failure mode
FM-01: 톱이 시작되지 않거나 아무 반응도 없음
- 잠금 해제 버튼과 트리거를 눌러도 motor 또는 블레이드가 움직이지 않음 - 작업등이 꺼져 있을 수 있음.
진단 개요
- 잠금 해제 버튼과 트리거를 눌러도 motor 또는 블레이드가 움직이지 않음 - 작업등이 꺼져 있을 수 있음.
예상 근본 원인
- Battery pack is discharged, too hot or cold, or faulty
- Pack is not fully seated or its contacts are obstructed
- Trigger lock-off button is not fully released or is damaged
- Trigger movement is blocked or damaged
- Internal switch, controller, or motor fault
빠른 점검
- The saw starts normally with a latched known-good pack.
수리 미리보기
- Release the trigger, remove the battery, and let all blade motion stop.
- Inspect the battery rails, contacts, lock-off, and trigger for damage or loose dry debris.
- Install a charged known-good compatible pack until it latches, then press lock-off and pull the trigger.
- - Test at no load - if motor, blade, and worklight stay dead, keep the saw out of service.
이것은 전체 수리 매뉴얼에 포함된 문제 해결 안내의 미리보기입니다.
일반적인 수리
- 호환 가능한 FLEXVOLT battery
- 트리거 및 전자 module
- 완전한 톱
- 트리거 잠금 해제 및 트리거
- FLEXVOLT battery 인터페이스
- 전자 module 및 motor
관련 증상
톱이 시작되지 않거나 아무 반응도 없음
- 잠금 해제 버튼과 트리거를 눌러도 motor 또는 블레이드가 움직이지 않음 - 작업등이 꺼져 있을 수 있음.
전체 매뉴얼에 포함
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
공개 페이지에는 미리보기만 표시됩니다. 전체 수리 단계, 다이어그램 및 검증 절차를 다운로드하려면 전체 매뉴얼을 구매하세요.