model
DCB115
DeWalt DCB115는 12V MAX, 20V MAX 및 FLEXVOLT battery 팩용 단일 포트 리튬 이온 battery 충전기입니다. 북미 시장용 120 V AC 입력과 4 A 단일 단계 충전 출력을 특징으로 합니다.
보고된 수리 성공률 0%
모델 세부 정보
모델 번호: DCB115
다른 이름으로도 알려진: DeWalt, DeWalt Tools, DeWalt Power Tools, DCB115
증상
- The battery stops before the fully seated position and the charger cannot begin a normal charge. No visible charger crack, conductive debris, or swollen pack has yet been confirmed.
yet been confirmed. and the charger for cracked rails; use FM-17 or FM-18 if found.
- POWER CORD OR PLUG IS DAMAGED, LOOSE, SCORCHED, OR HOT
Stop using it and unplug by the plug only if the connection is safe to POWER CORD OR PLUG IS DAMAGED, LOOSE, Remove the battery, unplug the charger, and take it off the wall before correcting the mount.
- 충전기가 비정상적으로 뜨겁거나 젖었거나 탄 단자가 있음
전원을 차단하고 충전기와 팩을 자연스럽게 식히십시오. 충전기가 비정상적으로 뜨겁거나 젖었거나 단자가 탔습니다. 손상된 팩은 삽입하거나 재충전하지 말고 안전할 때만 제거하십시오.
- The red light keeps blinking while the yellow indicator stays on even after the battery and charger have naturally reached an allowed room-temperature environment.
The red light keeps blinking while the yellow indicator Remove the battery and let it reach normal room temperature naturally;
- Metal chips, grinding dust, steel wool, foil, or another dry conductive buildup is visible in the battery cavity, around contacts, or at ventilation slots. No liquid or active smoke, spark, burning, or melting is present.
Metal chips, grinding dust, steel wool, foil, or another dry 1. Unplug the charger and remove the battery before a conductive particle
- Liquid has entered the charger or battery interface, or the charger shows smoke, sparks, burning odor, charring, melting, or active electrical arcing.
Liquid has entered the charger or battery interface, or Warn other people away and disconnect power only from a safe
- 완전히 장착되고 물리적으로 정상인 호환 battery 하나는 빨간색 또는 노란색 불이 들어오지 않으나 동일한 DCB115는 다른 알려진 정상 호환 팩을 같은 검증된 콘센트에서 충전 시작.
완전히 장착되고 물리적으로 정상인 호환 battery가 빨간색 또는 노란색 표시등을 켜지 않지만 동일한 DCB115는 다른 정상 팩을 충전합니다. 충전기 플러그를 뽑고 거부된 단일 팩을 제거하십시오.
- The attached cord or plug is cut, frayed, crushed, loose, discolored, scorched, or abnormally hot. There is no current smoke, spark, flame, melting charger housing, or liquid ingress.
The attached cord or plug is cut, frayed, crushed, loose, 1. Stop using the charger and unplug it by the plug only if the connection is
- A battery intended for the charger has physical damage, swelling, leakage, wetness, burned or melted terminals, or a deformed case. It may or may not still fit the charger.
A battery intended for the charger has physical damage, 1. Do not insert or recharge the damaged pack; if it is already in the
- The charger has dry visible structural damage to its upper or lower housing, tabletop feet, battery rails, retention area, contact support, or rear wall-mount slots. No liquid, smoke, spark, burning, or melting is active.
The charger has dry visible structural damage to its Unplug the charger and remove the battery before handling or flexing
- Independent checks show the battery charges and powers a tool normally, but the red or yellow indicator is too dim to read, remains stuck, stays on after pack removal, or does not match the label pattern.
Independent checks show the battery charges and Unplug the charger, remove the pack, and clean only the outside of the
- The charger housing becomes much hotter than normal charging warmth or operation repeatedly pauses as the charger heats, but there is no smoke, spark, burning odor, liquid, melting, swollen pack, or visible structural damage.
The charger housing becomes much hotter than normal Disconnect power, remove the battery, and let both complete items cool
고장 모드
- FM-17: BATTERY가 균열, 팽창, 누수, 젖음 또는 터미널이 그을림
FM-17 BATTERY가 균열, 팽창, 누수, 젖음 또는 터미널이 그을림
- FM-03: BATTERY가 충전기에 갇히거나 해제되지 않음
FM-03 BATTERY가 충전기에 갇히거나 해제되지 않음
- FM-05: 하나의 호환 팩이 불이 켜지지 않고 다른 팩은 충전됨
FM-05 하나의 호환 팩이 불이 켜지지 않고 다른 팩은 충전됨
- FM-15: 전도성 이물질이 BATTERY 슬롯 또는 통풍구에 있음
FM-15 전도성 이물질이 BATTERY 공간 또는 통풍구에 있음
- FM-19: 온전한 슬롯에도 벽걸이형 충전기가 흔들리거나 분리됨
FM-19 벽걸이형 충전기가 온전한 슬롯에도 흔들리거나 분리됨
- FM-06: 팩이 실온으로 돌아온 후에도 온도 지연이 남아 있음
FM-06 팩이 실온으로 돌아온 후에도 온도 지연이 남아 있음
- FM-01: 장착된 팩에 표시등 또는 충전 반응 없음
FM-01 장착된 팩에서 표시등 또는 충전 반응 없음
- FM-02: BATTERY가 충전기에 완전히 미끄러지거나 장착되지 않음
FM-02 BATTERY가 충전기에 완전히 삽입되거나 장착되지 않음
- FM-16: 액체가 침투했거나 충전기에서 연기, 불꽃, 연소 또는 녹음 발생
FM-16 액체가 침투했거나 충전기에서 연기, 불꽃, 연소 또는 녹음 발생
- FM-13: 충전기 플러그 연결 시 차단기 또는 GFCI 작동
FM-13 충전기를 연결할 때 차단기 또는 GFCI가 작동함
- FM-11: 충전이 정상인데 표시등이 흐리거나 멈추거나 잘못됨
FM-11 충전이 정상인데 표시등이 흐리거나 멈추거나 잘못됨
- FM-04: BATTERY가 충전기에 장착되지만 고정되지 않음
FM-04 BATTERY가 충전기에 장착되지만 고정되지 않음
관련 문제 해결
Common symptoms
- The battery stops before the fully seated position and the charger cannot begin a normal charge. No visible charger crack, conductive debris, or swollen pack has yet been confirmed.
- POWER CORD OR PLUG IS DAMAGED, LOOSE, SCORCHED, OR HOT
- 충전기가 비정상적으로 뜨겁거나 젖었거나 탄 단자가 있음
- The red light keeps blinking while the yellow indicator stays on even after the battery and charger have naturally reached an allowed room-temperature environment.
- Metal chips, grinding dust, steel wool, foil, or another dry conductive buildup is visible in the battery cavity, around contacts, or at ventilation slots. No liquid or active smoke, spark, burning, or melting is present.
- Liquid has entered the charger or battery interface, or the charger shows smoke, sparks, burning odor, charring, melting, or active electrical arcing.
- 완전히 장착되고 물리적으로 정상인 호환 battery 하나는 빨간색 또는 노란색 불이 들어오지 않으나 동일한 DCB115는 다른 알려진 정상 호환 팩을 같은 검증된 콘센트에서 충전 시작.
- The attached cord or plug is cut, frayed, crushed, loose, discolored, scorched, or abnormally hot. There is no current smoke, spark, flame, melting charger housing, or liquid ingress.
- A battery intended for the charger has physical damage, swelling, leakage, wetness, burned or melted terminals, or a deformed case. It may or may not still fit the charger.
- The charger has dry visible structural damage to its upper or lower housing, tabletop feet, battery rails, retention area, contact support, or rear wall-mount slots. No liquid, smoke, spark, burning, or melting is active.