failure mode
FM-20: LA FRIZIONE NON SI SGANCIA MAI E SOVRACCARICA I FISSAGGI A IMPOSTAZIONI BASSE
FM-20
Panoramica diagnostica
FM-20
Cause probabili
- Collar is actually in drill mode or a high setting
- Fastener, bit, or scrap material is unsuitable for the comparison
- Clutch cam, spring, or detent is jammed
- Gearbox or spindle bypasses the torque-limiting mechanism
Controlli rapidi
- The clutch ratchets before overdriving at an appropriate low setting, or the no-release fault is proven.
Anteprima riparazione
- Install a verified battery and drive slowly while holding the tool straight, stopping immediately if the fastener begins to overdrive without ratcheting.
- If several low settings never release under a valid comparison, remove the battery and route the clutch and gearbox to service.
- Remove the battery and set up a matching fastener and sound driver bit in suitable scrap material.
- Set the collar to a low numbered position, use range 1, and confirm the index is not on drill mode.
Questa è un'anteprima della guida alla risoluzione dei problemi inclusa nel manuale di riparazione completo.
Sintomi correlati
Il collare si muove e mantiene un'impostazione numerata bassa, ma la frizione non scatta prima che un fissaggio di prova venga sovraccaricato in materiale di scarto adatto.
La ghiera si muove e mantiene un'impostazione numerata bassa, ma la 1. Rimuovere il battery e preparare un fissaggio corrispondente e una punta di avvitatore funzionante in materiale di scarto adatto.
Incluso nel manuale completo
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
Le pagine pubbliche mostrano solo un'anteprima. Acquista il manuale completo per scaricare passaggi di riparazione, diagrammi e procedure di verifica completi.