failure mode
FM-20: EL EMBRAGUE NUNCA SE LIBERA Y SOBREPASA LOS SUJETADORES EN AJUSTES BAJOS
FM-20
Resumen de diagnóstico
FM-20
Causas probables
- Collar is actually in drill mode or a high setting
- Fastener, bit, or scrap material is unsuitable for the comparison
- Clutch cam, spring, or detent is jammed
- Gearbox or spindle bypasses the torque-limiting mechanism
Comprobaciones rápidas
- The clutch ratchets before overdriving at an appropriate low setting, or the no-release fault is proven.
Vista previa de reparación
- Install a verified battery and drive slowly while holding the tool straight, stopping immediately if the fastener begins to overdrive without ratcheting.
- If several low settings never release under a valid comparison, remove the battery and route the clutch and gearbox to service.
- Remove the battery and set up a matching fastener and sound driver bit in suitable scrap material.
- Set the collar to a low numbered position, use range 1, and confirm the index is not on drill mode.
Esta es una vista previa de la guía de solución de problemas incluida en el manual de reparación completo.
Síntomas relacionados
El collar se mueve y mantiene una configuración numérica baja, pero el embrague no trinca antes de que un sujetador de prueba sea sobrepasado en material de desecho adecuado.
El collar se mueve y mantiene una configuración numérica baja, pero el 1. Retire el battery y prepare un sujetador coincidente y una broca de conductor sonora en
Incluido en el manual completo
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
Las páginas públicas muestran solo una vista previa. Compra el manual completo para descargar los pasos de reparación, diagramas y procedimientos de verificación completos.