Symptomer
Gennemse dokumenterede symptomer, og spring til matchende reparationsguider fra søgeresultaterne.
The robot stops with Error 68 because its camera failed during the cleaning job.
0 relaterede manualer
Find guider →
The drill runs steadily but drills slowly or cannot drive a normal fastener with correct setup.
0 relaterede manualer
Find guider →
The robot reports four beeps immediately after an attempted start.
0 relaterede manualer
Find guider →
The app reports Error 21, 25, 34, 38, 39, 47, 66, or 76 and the robot cannot reliably continue.
0 relaterede manualer
Find guider →
The robot stops and reports five beeps while wedged or unable to escape.
0 relaterede manualer
Find guider →
The bit jams, the motor stalls, or the drill twists sharply in the hands during work.
0 relaterede manualer
Find guider →
The running saw jumps, vibrates against the work, snags, or kicks backward or sideways.
0 relaterede manualer
Find guider →
A genuine m Series pad is fully seated in both tracks, but the robot refuses to run or selects the wrong pad state.
0 relaterede manualer
Find guider →
With the battery removed and no bit fitted, the chuck will not hand-turn normally or feels seized.
0 relaterede manualer
Find guider →
After the trigger is released, the blade keeps stroking noticeably longer than normal.
0 relaterede manualer
Find guider →
The robot stops with a drive wheel hanging over a step or threshold and reports six beeps.
0 relaterede manualer
Find guider →
With a secure known-good blade clear of the work, the saw has harsh sound, bind, or vibration.
0 relaterede manualer
Find guider →
The robot stops and reports eight beeps because its wheels cannot turn.
0 relaterede manualer
Find guider →
A secure straight bit and clear work do not eliminate harsh no-load sound or vibration.
0 relaterede manualer
Find guider →
A correct m Series pad binds in the tracks, will not seat flat, or will not release when the eject button is pressed.
0 relaterede manualer
Find guider →
The robot reports ten beeps after the distress sound.
0 relaterede manualer
Find guider →
The tool, pack, or charger becomes unusually hot, or protection repeatedly stops operation.
0 relaterede manualer
Find guider →
The tank is filled to the top and installed flat, but the red sweep or Error 37 still says to fill it.
0 relaterede manualer
Find guider →
The saw, battery, or charger becomes abnormally hot or repeatedly shuts down after warming.
0 relaterede manualer
Find guider →
The robot repeatedly reverses, circles, turns in place, or drifts instead of following a stable path.
0 relaterede manualer
Find guider →