Saven skærer langsomt, føles svag, brænder træ eller efterlader et ru snit

Klingen når en stabil normal tomgangshastighed, men skæringen er usædvanligt langsom, kræver kraftigt fremførsel, brænder træet eller producerer overdreven flisning uden fuld standsning.

• Blade is dull, dirty, wrong tooth count, installed backward, or unsuitable for the wood
• Depth is excessive or bevel/depth levers are not secured
• Feed is too fast, material is wet/dense, or the shoe is not flat
• Battery capacity is low or internal drive drag appears only under load

1. A sharp correct blade makes a controlled cut at normal feed with no burning, excessive splintering, laboring, or unusual battery heat.

1. Release the trigger, wait for a full stop, remove the battery, and inspect the cut rather than increasing force.
2. - Verify blade type, tooth condition, rotation direction, clean clamp stack, and secure mounting - replace a dull, dirty, damaged, or unsuitable blade.
3. Set depth to about one-half tooth below the material, lock depth and bevel, support the work, keep the shoe flat, and use an unforced feed rate.
4. - Compare one cut using a known-good fully charged compatible pack - if normal no-load speed remains but cutting stays weak with a correct sharp blade and set

Dette er en forhåndsvisning af fejlfindingvejledningen, der er inkluderet i den fulde reparationsmanual.

• FM-19: Fm Dcs578 19

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser kun en forhåndsvisning. Køb den fulde manual for at downloade komplette reparationstrin, diagrammer og verifikationsprocedurer.