Battery vil ikke installeres, låses eller frigives fra saven

En kompatibel udseende pakke glider ikke helt på skinnerne, forbliver ikke låst, eller kan ikke trækkes fri, når udløserknappen trykkes.

• Pack is misaligned, incompatible, swollen, or damaged
• Sawdust or a bent rail is obstructing travel
• Battery release button or latch is jammed, cracked, or not returning
• Handle rails or battery-interface housing are damaged

1. The pack slides on without force, clicks securely, cannot disengage unintentionally, and releases normally when the button is pressed.

1. Place the saw on a stable side surface, release the trigger, and do not force, hammer, or pry the pack.
2. Inspect the pack case, rails, latch, release button, and saw rails for debris, swelling, cracks, heat damage, or bent plastic.
3. Clean the rails dry, align the pack squarely, slide until it latches, or press the release fully and pull the pack straight out.
4. - Compare with a known-good compatible pack - if the tool rails, latch, release, or housing remain damaged or jammed, keep the saw out of service for authoriz

Dette er en forhåndsvisning af fejlfindingvejledningen, der er inkluderet i den fulde reparationsmanual.

• FM-04: Fm Dcs578 04

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser kun en forhåndsvisning. Køb den fulde manual for at downloade komplette reparationstrin, diagrammer og verifikationsprocedurer.