Arbejdslyset fejler, blinker eller forbliver tændt langt ud over sin normale forsinkelse

motor fungerer normalt, men det integrerede arbejdslys lyser ikke, blinker med en stabil battery, eller forbliver tændt meget længere end den normale forsinkelse efter udløser.

• Worklight lens or opening is packed with sawdust
• Battery or trigger input is intermittent
• LED, light wiring, or electronic timing control has failed
• Normal delay of about 20 seconds is being mistaken for a fault

1. The worklight illuminates steadily with trigger operation and turns off automatically after its normal delay.

1. - Confirm the motor operates normally and time the light only after the trigger is fully released - a delay of about 20 seconds is normal.
2. Remove the battery and clean the light opening and surrounding external area with a dry brush or clean dry air.
3. Install a known-good fully charged compatible pack and repeat a brief no-load trigger-and-release check.
4. If the motor remains normal but the light still fails, flickers, or remains on abnormally, leave the housing closed and request authorized light or control

Dette er en forhåndsvisning af fejlfindingvejledningen, der er inkluderet i den fulde reparationsmanual.

• FM-12: Fm Dcs578 12

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser kun en forhåndsvisning. Køb den fulde manual for at downloade komplette reparationstrin, diagrammer og verifikationsprocedurer.