Skæredybden vil ikke indstilles, låses, holdes eller nå sit normale område

Skoen vil ikke glide til den ønskede klingeblottelse, dybdestangen vil ikke klemme, dybden ændres under skæring, eller maksimal dybde er tydeligt utilgængelig med en korrekt klinge.

• Sawdust is packed at the depth guide, lever, or shoe slide
• Depth lever is loose, stripped, cracked, or incorrectly adjusted
• Shoe, depth guide, or guard is bent or obstructed

1. The depth moves freely, locks without slip, repeats the chosen exposure, and allows the specified normal range with the correct blade.

1. Remove the battery, loosen the depth lever, and clear exposed dry sawdust from the depth guide, lever, and shoe movement path.
2. Confirm the correct blade is centered and clamped, and inspect the shoe, guide, lever, and lower guard for bend, crack, interference, or missing hardware.
3. Move the shoe to expose about one-half tooth below the intended material and retighten the lever in the official direction before cutting.
4. - Check that the setting does not move by hand and that normal travel includes up to 2-9/16 inches at 90 degrees with the correct blade - if not, use authoriz

Dette er en forhåndsvisning af fejlfindingvejledningen, der er inkluderet i den fulde reparationsmanual.

• FM-23: Fm Dcs578 23

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser kun en forhåndsvisning. Køb den fulde manual for at downloade komplette reparationstrin, diagrammer og verifikationsprocedurer.