Den nederste klingebeskytter sidder fast, lukker langsomt, berører klingen eller vil ikke lukke

Den fjederbelastede nederste beskyttelse bevæger sig ikke frit gennem alle vinkler/dybder, lukker ikke hurtigt, gnider mod klingen eller kræver manuel hjælp under almindelige snit.

• Sawdust, gum, or a small cutoff is obstructing the guard path
• Guard, retracting lever, pivot, or spring is bent, worn, damaged, or misassembled
• Blade or clamp stack is wrong and contacts the guard
• Guard was tied open, lubricated, or damaged by impact

1. With the battery removed, the lower guard moves freely without blade contact and snaps closed promptly at every tested depth and bevel position.

1. Remove the battery immediately and do not use the saw while the lower guard is missing, tied open, slow, damaged, or contacting the blade.
2. Use the retracting lever to move the guard through its full travel at several depth and bevel settings, checking for free motion and prompt spring closure.
3. - Clear dry sawdust, gum, and small offcuts externally - inspect the guard, lever, pivot, spring area, blade, and clamp stack for bend, rub, damage, or wrong
4. Confirm a correct centered blade and clean clamp area, and do not lubricate the guard/clamp region.
5. If the guard does not close freely and promptly at every setting, keep the battery out and have the complete guard system repaired by authorized service.

Dette er en forhåndsvisning af fejlfindingvejledningen, der er inkluderet i den fulde reparationsmanual.

• FM-24: Fm Dcs578 24

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser kun en forhåndsvisning. Køb den fulde manual for at downloade komplette reparationstrin, diagrammer og verifikationsprocedurer.