搜索维修指南
在知识库中查找维修指南、手册、症状和错误代码。
Charger green LED stays on
Tool rotates, but a seated fastener gets little torque or no normal impact pulse.
THE BATTERY WILL NOT SEAT, LATCH, RELEASE, OR STAY SECURE
Unit shuts off abruptly
Narzędzie, akumulator lub ładowarka nagrzewa się nadmiernie lub ochrona wielokrotnie zatrzymuje pracę.
Chuck clicks while tightening
Klemmen vil ikke bevege seg
Med klämspaken fungerande går ett korrekt blad inte i helt eller klarar handdragstest.
Trigger binds, fails to return, changes speed erratically, or does not stop the drive.
The direction lever will not reach forward, reverse, or center lock, or the selected position does not hold.
WORKLIGHT COMES ON, BUT THE MOTOR WILL NOT START
After trigger release, the bit or square drive coasts noticeably longer than normal before stopping.
A straight bit traces a visible circle at no load instead of rotating on a stable centerline.
The motor can be heard, but the front output remains still in both directions with the bit removed.
The trigger returns normally and power drops, but the anvil repeatedly coasts instead of stopping promptly.
BATTERY WILL NOT CHARGE
Pakiet nie ładuje się lub lampka ładowarki pozostaje wyłączona lub pokazuje nienormalny czerwony wzór.
A seated battery shows no charge response, or charge never reaches a usable full state.
A straight bit or socket visibly orbits, shakes, or runs off-center during a brief no-load test.
battery无法完全滑入手柄、锁定、保持或正常释放。
FM-02: 电池组无法安装、锁定或释放
fm-3-2: CHARGE-STATUS INDICATOR GIVES NO RESPONSE AFTER A CONFIRMED FULL CHARGE
fm-1-1: 锁定的 BATTERY 无法从接收器释放
FM-15: FM-15 BATTERY 存储断开连接时快速失电
FM-01: 无 LED 或 motor 响应 通过 FM-01 验证充电、电池安装、中心锁位置、触点和触发器
fm-p13-b-17e1d6d1: 锁止或触发卡滞，无法完全移动，启动
FM-07: FM-07: A compatible pack stops on the rails, will not reach full
fm-3-1: FM-07 导板、链条或链轮罩无法安装或就位
FM-06: 电池组恢复至室温后仍存在冷热延迟
FM-05: 如果锯子在确认有电且控制自由的情况下仍无反应，保持机壳关闭，
FM-18: FM-18 A KNOWN-STRAIGHT BIT SHOWS VISIBLE WOBBLE OR RUNOUT
FM-14: FM-14 空载行程磨擦、敲击、卡滞或振动
FM-04: FM-04 运行时间非常短或工具突然关闭
FM-12: FM-12 钻头卡滞、卡死或扭转钻机
FM-11: FM-11 刀片偏移、弯曲或断裂
FM-16: FM-16 立即BATTERY、充电器、液体或结构危险
FM-03: FM-03 BATTERY无法开始或完成充电
FM-15: FM-15 工具或BATTERY过热或反复关机
FM-16: FM-16 BIT WILL NOT RELEASE, OR A SHORT OR BROKEN BIT IS TRAPPED
FM-10: 切割不方正或斜切角度不准确