FM-14: 锯子或 Battery 过热或反复热关断

锯或电池组异常发热，输出下降或切割中断。

• Vents are blocked by sawdust or the saw is covered
• Blade is dull or the feed load is excessive
• Battery is hot, cold, low, damaged, or unsuitable
• Cut depth, support, or material is overloading the saw
• Motor, bearing, controller, or battery fault

1. A light supported cut completes without abnormal heat or shutdown.

1. Release trigger, remove pack, and place both on a clear surface.
2. Let saw and pack cool naturally, then brush the vents and inspect for damage or odor.
3. - Fit sharp blade and good pack - correct depth and support - test lightly.
4. If abnormal heat or shutdown returns, stop use and seek qualified service.

这是完整维修手册中所含故障排除指南的预览。

• 手柄、外壳、通风口
• FLEXVOLT battery 接口
• 兼容FLEXVOLT battery
• 电子 module 和 motor
• Motor、齿轮箱或主轴

• 锯子或 Battery 过热或反复热关断

  锯或电池组异常发热，输出下降或切割中断。

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。