FM-11: 工作灯无法正常工作

工作灯熄灭、闪烁，或触发释放后的延时异常。

• Battery charge is too low for a valid test
• Trigger is not moving far enough to activate the light
• Lens area is blocked by dry debris
• LED or wiring is damaged
• Switch or electronic control fault

1. The worklight activates with the trigger and turns off after normal delay.

1. Remove the saw from the work and install a charged known-good battery.
2. Operate lock-off and trigger briefly while watching the light.
3. Brush only loose dry debris from the lens area and repeat the no-load timing check.
4. If the light stays dark, flickers, or times incorrectly, use qualified service.

这是完整维修手册中所含故障排除指南的预览。

• 工作灯及镜片
• 工作灯、外壳或导轨

• 工作灯无法正常工作

  工作灯熄灭、闪烁，或触发释放后的延时异常。

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。